PH10 PLUS

PH10 PLUS motorized indexing heads

There are three PH10 PLUS models, each of which can carry a range of probes and extensions and can be orientated in 720 repeatable positions, giving access to the most difficult to reach work piece features. This enables the inspection of features at different angles without the need for frequent, time consuming stylus cluster changes.

All three variants of the new PH10 heads are now supplied with a revised repeatability specification, down from 0.5 microns to just 0.4 microns (at a specified distance of 62mm), giving users improved positioning at the stylus tip. The new specification heads are physically differentiated by a new “aqua blast” which gives a more modern, matte black finished appearance.

 

PH10M PLUS

The PH10M PLUS can carry long extension bars and complex probes such as SP25M or TP7M. The highly repeatable autojoint allows rapid probe or extension bar changing without the need for re-qualification.

Length 117 mm
Width 62 mm
Weight 620 g
Probe mounting Autojoint (multiwire)
Head mounting PH10M PLUS  shank to suit CMM
Suitable controller PHC10-3 PLUS
Repeatability of position 0.4µm (0.00002 in) specified at a distance of 100mm
Total number of positions 720
Maximum recommended drive torque 0.45Nm
Maximum extension bar 300mm (11.8 in) using PAA3 extension

450mm (17.7 in) using PAACF special order only extention

 

PH10MQ PLUS

The PH10MQ PLUS is a variant of the PH10M PLUS that allows the motorized head to be attached directly to the quill with the B-axis of the head inside the quill itself.

This option provides a neater and shorter probe mount, with only the A-axis protruding from the quill.

Length 73 mm
Width 80 mm
Weight 730 g
Probe mounting Autojoint (multiwire)
Head mounting Direct to quill
Suitable controller PHC10-3 PLUS
Repeatability of position 0.4µm (0.00002 in) specified at a distance of 100mm
Total number of positions 720
Maximum recommended drive torque 0.45 Nm
Maximum extension bar 300 mm (11.8in) using PAA3 extension 450 mm (17.7 in) using PAACF special order only extention

 

PH10T PLUS

The PH10T PLUS is similar to the PH10M PLUS, except that it features an M8 thread probe mount in place of the autojoint.

All M8 threaded probes, such as TP20 and TP200, and extension bars fit directly onto the head. The PH10T PLUS is fully compatible with all of Renishaw’s stylus and module change systems.

Length 103 mm
Width 62 mm
Probe mounting M8 thread (2-wire)
Head mounting Shank to suit CMM
Suitable Controller PHC10-3 PLUS
Repeatability of position 0.4µm (0.00002 in) specified at a distance of 100mm
Maximum recommended drive torque 720
Maximum extension bar 300 mm (11.8 in) using PEL4 extension